Galeco Industrial Downpipe Bend - 87 Degree x 100mm Graphite

87 Degree Bends are used in a downpipe system to change the plane of the bend from vertical to horizontal or vice versa.They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup.The angle of the bend is 87 degrees rather than 90 degrees to encourage a slight fall, enabling rainwater to run away rather than sit in the pipe.The sleek Graphite finish not only provides a modern aesthetic but is also resistant to fading, corrosion, and wear, ensuring low maintenance over time.Ideal for larger roof areas, this gutter is engineered for easy installation and seamless integration with existing drainage systems.